Pro 2300-PSI Brushless 2.3-GPM Electric Pressure Washer

Hello Lazetar, Our units have a standard M22 14mm fitting.

Hello Kevdee, There are a few options including second-story nozzles or extension wands. While we do not offer these products, they can be purchased from other brands that may be compatible. The extension wand would have to be connected to our wand using a 1/4" quick connect fitting to the end of the existing wand, however, please know that the pressure may be affected as the units were not technically designed to be used with an extension wand. You could also try second-story nozzles in lieu of an extension wand! They would have to be 1/4" quick connect nozzles. I hope this helps!

Hello Ridget, This product weighs 36.4 lbs. (16.5 kg). The dimensions are approximately 36 x 20 x 20 inches.

Hello, We do not offer extension wands for our pressure washers. While we do not offer these products, they can be purchased from other brands that may be compatible. The extension wand would have to be connected to our wand using a 1/4" quick connect fitting to the end of the existing wand, however, please know that the pressure may be affected as the units were not technically designed to be used with an extension wand. You could also look at second-story nozzles in lieu of an extension wand! They would have to use a 1/4" quick connect fitting as well.

Hello Andrew66, This issue is likely caused by a few factors such as excess air trapped in the pump or clogged nozzles. Here you will find some troubleshooting suggestions to resolve these issues. 1) To clean the nozzles, soak all of your nozzles in a half and half mixture of warm water and white vinegar. Soak all the nozzles for about an hour and then proceed to poke your nozzle cleaning tool or paper clip through the end of the nozzle hole to poke out any debris. After you have done this, rinse them with warm water. Your nozzles will now be free of any obstructions causing the unit to malfunction. 2) Purge any excess air from the pump. Set up the unit as per usual and ensure you are not using an extension cord. Remove any nozzle that may be connected at the end of the wand. Make sure that you have a green light on the GFCI on the power cord. Turn your garden hose on but leave the pressure washer turned OFF. With the pressure washer turned off, squeeze on the trigger for about 3 minutes – allowing the water to run through the unit at no pressure. In doing so, you are bleeding the unit out of any air that may be stuck in the pump. After 3 minutes, turn the unit on. If it is running, reinstall one of your clean nozzles and continue using the unit. *Follow exactly as written* If issues persist, please contact us at 1-888-909-6757 or send an email to info@greenworkstools.com.

Hello, Soap will only come out when you have the black sop nozzle on. Once you switch nozzles, only water will come through. *NOTE: You may see suds for about 10 seconds once you switch nozzles as it is clearing from the hose but they will quickly disappear.

Hello, Yes, all threaded connections are an M22 14mm fitting. The end of the wand is a 1/4" quick connect for the nozzles.

Hello, Thank you for sharing! So glad to read that you are loving your new pressure washer. You may absolutely use this to wash windows, just be sure to have on the right nozzle. You should use the 40-degree or 25-degree nozzle for this task. As always, be sure to test the nozzle in an inconspicuous area to ensure you do not provide damage to the surface. If storing in the garage/shed over the winter, be sure to also use a pressure washer pump protector to prevent cold weather damage during storage. The best storage procedure is to bring the unit indoors if possible but not too close to a furnace either otherwise pump seals may dry out.